Temperature Control; Moving Your Appliance - Domo DO988RKZ Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
·
Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
·
Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the
evaporator, and your refrigerator.
·
Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
·
The appliance must be grounded. The manufacturer is not responsible for damages that may occur as
a result of usage without grounding.
·
After installation, leave the freezer for 8 hours before turning it on. This way the refrigerant can settle.
·
Allow the appliance to run empty for 24 hours so the compartment can cool to the appropriate
temperature.
·
This appliance is designed to operate in ambient temperature between 16°C and 38°C. If these
temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly.
·
The appliance may only be used indoors.
USE

TEMPERATURE CONTROL

The fridge is controlled with a temperature control knob located inside the
appliance.
Adjust the control knob as desired to suit your individual preference.
·
COLDER: 0-4°C
·
NORMAL: 4-7°C
·
COLD: 7-10°C
·
OFF
·
The running time and temperature are affected by where the freezer is located, how often the door is
opened and the temperature of the room the freezer is located in.
·
When you use the appliance for the first time or after defrosting, adjust the control knob to the coldest
setting for at least 2 hours before introducing food to be stored, and then readjust to the middle
setting.

MOVING YOUR APPLIANCE

If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will allow
the refrigeration system pressures to equalise before restarting.
·
Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile
parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
·
Relocate and install. If the appliance has been left on its side for any length of time, leave it standing
upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly
and natural gas, it is explosive. Therefore you should be careful during shipment and installation to
prevent your appliance's cooler elements from being damaged. In the event of a leak caused by damage
to the cooler elements, move your fridge from open flame or heat sources and ventilate the room where
the appliance is located for a few minutes.
www.domo-elektro.be
25
DO988RKZ

Publicité

Table des Matières
loading

Table des Matières