Kathrein EXE 159 Mode D'emploi page 10

Integrated AGC (Automatic Gain

Control) ensures a constant output
level in the Sat-IF range
EXE 259 single-cable multi-switches

and additional loop-through multi-
switches such as EXR 2541, EXR
2554, EXR 2558 and EXR 2542 can be
combined as desired.
Up to eight multi-switches can be

cascaded
For indoor installation


EXE 159
Single-cable multi-switch for up to nine

receivers, with an integrated power
supply unit for LNB supply
Low power consumption due to highly

effi cient, short-circuit proof switched-
mode power supply unit in compliance
with ERP guideline and energy-saving
concept (the single-cable multi-switch
is switched off whenever the connected
receiver is switched off)
All manuals and user guides at all-guides.com


EXE 259



2 / 8 2 / 8
Kathrein Power Saving:
LNB supply is switched off as soon
as all receivers connected to the EXE
159 or in the cascade are inactive.
This function can be deactivated; e.g.
if loop-through multi-switches without
Kathrein Power Saving are used in the
cascade
LNB remote feeding via the horizontal
low input. Kathrein Power Saving
signalling over the vertical low trunk. All
other inputs are voltage-free
Loop-through multi-switch to extend a
single-cable system for an additional
nine receivers
Kathrein Power Saving: As soon as all
receivers are inactive, a signal is sent
to the end multi-switch via the vertical
low trunk which then cuts off the LNB
voltage supply.
Optional powering using the NCF 18.
Due to the energy-saving concept, the
multi-switch consumes no energy from
the NCF 18 if no receivers are switched
on.