Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Drilling the Support surface and Fit-
ting the Hood
SCREW FITTING
• The hood support surface must be 135 mm
above the bottom surface of the wall units.
• Drill the support with a ø 4,5 mm drill bit, using
the drilling template provided.
• Cut a hole ø 125 mm in size on the support sur-
face, using the drilling template provided.
• Fix using the 4 screws 12a (4,2 x 44,4) provid-
ed.
SNAP-ON FITTING
• The hood can be installed either directly on the
bottom surface of the wall units using snap-on
side supports.
• Cut a fitted opening in the bottom surface of the
wall unit, as shown.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf from
underneath the hood.
CLOSING ELEMENT
• The space between the edge of the hood and the
rear wall can be closed by applying the element
20 provided, using the screws supplied for this
purpose.
GB
All manuals and user guides at all-guides.com
���
���
���
���
��
��
��
12
Publicité
