Koma 08722 Manuel D'instructions page 30

MONTAJE
ES
Installing and removing bits (Fig.2)
▶ To fit a screwdriver bit, push it into the bit holder until it locates.
▶ To remove a screwdriver bit, pull it straight from the bit holder.
PT
Make sure it is fully in place before use.
Trigger switch (Fig.3)
▶ Start the tool by press the trigger switch
EN
▶ Release the switch to stop the machine.
LED working light (Fig. 3)
FR
This tool is equipped with a LED light at the front to work in darker
areas.
Reversible (Fig. 4)
The forward/ reverse rotation control located above the trigger
switch controls the direction of rotation. For screw driving by using
forward rotation, press the rotation lever on the right position.
For removing screws or release a jammed drill bit by using reverse
rotation, press the rotation lever on the left position to remove
screws.
Adjustable/twistable handle (Fig. 5)
The handle of the screwdriver may be angled or twisted for ease of
control, or a different operating environment. The handle is fixed in
position by a locking switch beside the power indicator light.
To adjust the handle angle, push and hold this switch forward and at
the same time move the handle to the desire position, release the
switch to lock the handle in the new position.
Note: Do not force the handle, ensure that you are turning it
in the correct direction.
Battery level indicator (Fig. 6)
The tool is equipped with power indicator light.
Press the on/off switch to view the battery charge status.
Instruction manual Ref. 08722