Resetting The Camera - Monacor INC-2622BV Mode D'emploi

To change the settings for the camera,
select the tab c and go to the view "Con-
fig . 7) . On the left ( i ),
figuration" ( ☞
select the desired category for the settings .
To show additional subcategories, click ⊞ .
To set, for example, the current time for the
camera, go to "Device  Date and Time" .
To save a setting that has been changed,
click the green check mark ✔ or the button
"Apply" . To load the current settings from
the camera, click the button "Refresh" .
Windows is a registered trademark of Microsoft Corporation in
the USA and other countries.

8 Resetting the Camera

When the camera is reset to its factory set-
tings, any changes the user has made to
the camera settings will be lost .
1) Release the screw (5) of the cover and
open the compartment .
2) Keep the Reset button (23) pressed
for more than 5 seconds (
chapter 4) . When the button is released,
resetting will start with a delay and may
take a few minutes .
3) Tightly close the cover again .
The camera is reset to the static IP address
192 .168 .0 .120 . The default user name and
the password for log-in is: admin
➆
All rights reserved by MONACOR
means for any commercial use.
9 Specifications
Image sensor: . . . . . . . . . CMOS, 8 .76 mm (10⁄29 ")
Lens: . . . . . . . . . . . . . . . . 1 : 1 .4/6 – 22 mm, with DC-controlled iris
Viewing angle: . . . . . . . . 11 .4° – 46 .5°
Minimum illumination: . . 0 .01 lx (colour), 0 .03 lx (B/ W)
Resolution: . . . . . . . . . . . 30 frames max . per second with 1920 × 1080 pixels
Electronic shutter: . . . . . . 1⁄5 – 1/20 000 s
Protocols: . . . . . . . . . . . . IPv4, IPv6, HTTPS, RTSP, DDNS, SMTP, SSL, ONVIF 2 .4 etc .
Compression: . . . . . . . . . MPEG-4 H .264, MJPEG
Video streaming: . . . . . . . Mainstream 500 – 12 000 kbit /s
Audio bit rate: . . . . . . . . 64 kbit/s
Network: . . . . . . . . . . . . Ethernet 10 /100 Mbit /s
Ambient temperature: . . −30 °C to +50 °C
IP rating: . . . . . . . . . . . . . IP 66
Power supply: . . . . . . . . . ⎓ 12 V/400 mA or PoE IEEE 802 .3af
Dimensions: . . . . . . . . . . ⌀ 110 mm × 377 mm
Weight: . . . . . . . . . . . . . 2 .5 kg
☞ fig . 4 in
Subject to technical modification .
i
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be reproduced in any form or by any
®
Substream 100 – 6000 kbit /s
11