Black & Decker GS2200 Mode D'emploi page 6

ENGLISH
Fit the wheel axle (11) to the frame using the screws (12),
washers (13) and nuts (14) as shown in fig. A1.
Turn the shredder into the upright position.
Fitting the collection bag (fig. B)
Place the collection bag (6) under the outlet opening as
shown.
Connecting the appliance to the mains
Note: The UK version may be supplied with a wired in supply
cable or power inlet.
Connect the female socket of a suitable extension cable
to the power inlet (7).
Insert the mains plug into a mains outlet.
Warning! The extension cable must be suitable for outdoor
use and for the power consumption of the appliance.
Use
Warning! Let the appliance work at its own pace.
Do not overload.
Do not switch the shredder off before it is completely
empty, as it may clog and be difficult to restart.
Remove soil and stones from plant roots before shredding.
Firmly hold branches when feeding them into the
shredder.
Switching on and off (fig. C)
Switching on
Set the direction selector (17) to the lower position
(A in fig. C).
Set the power switch (18) to position I.
Switching off
Set the on/off switch to position O.
Emergency stop
In an emergency, hit the stop button (19) to stop the
appliance.
Clearing a blockage (fig. C)
When the material is jammed:
Switch the appliance off.
Set the direction selector (17) to the upper position
(B in fig. C).
Set the power switch (18) to position I until the blockage
is removed.
Warning! Branches may be ejected from the inlet funnel
when the appliance is running in reverse.
6
All manuals and user guides at all-guides.com
If the blockage has not cleared:
Switch off and unplug the appliance.
Use a piece of wood to loosen the debris within the
cutting chamber.
Replace the plug in the mains socket and operate the
appliance as described above to remove any debris.
Warning! Always switch off and unplug the appliance when
removing a blockage. Do not attempt to remove blockages by
hand through the inlet funnel or outlet opening. Keep your
hands clear of the cutting chamber.
Hints for optimum use
Shred dry materials last, as this will help to clear moist
material from the shredder.
Do not allow material to pile up and compost prior to
shredding.
You may feed shreddings into the shredder for a second
time to further reduce their volume.
Refer to the chart at the end of this text.
Maintenance
Your Black & Decker appliance has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
appliance care and regular cleaning.
Keep the unit clean and dry.
Do not use any abrasive or solvent-based cleaner.
Regularly clean the ventilation slots in your appliance
using a soft brush or dry cloth.
Adjusting the pressure plate
The pressure plate is factory-adjusted and does not require
adjustment before first use. When the shredded material starts
to hang like a chain as shown in fig. D, adjust as follows:
Switch the appliance on.
Turn the adjustment knob (8) clockwise until you hear a
light grinding sound.
A small amount of aluminium shavings will fall out of the
appliance. The shredded material will now be separated as
shown in fig. E.
Overload protection
This appliance has an overload protection. If the appliance
becomes blocked and the motor stalls, the power will
automatically be switched off.
Wait for a few minutes for the protection to reset.
Clear the blockage as described above.