Publicité
Les langues disponibles
Les langues disponibles
Start-up
4 START-UP
IMPORTANT! Danger of material damage
due to incorrect mains voltage! Incorrect mains
voltage can damage the charging unit and the re-
chargeable battery.
■
Before connecting the charging unit, make
sure that the mains voltage matches the volt-
age stated in the "Technical data".
4.1
Setting up the charger
1. Remove the charger from the packaging.
2. Place the charger on a non-inflammable, lev-
el surface at a safe distance from other ob-
jects.
3. Insert the mains plug. The charger is ready
for operation.
4.2
Mounting the charger on the wall
The charger has two attachment holes (01/8)
89 mm apart on its underside. These allow the
charger to be attached to a vertical surface, e.g.
wall or board.
1. Screw two round-head screws into the sur-
face until the screw heads are protruding by
approx. 2 to 3 mm.
2. Hook the charger over the screw heads.
3. Check that the charger is securely supported.
If not, remove the charger again and screw
the screws slightly further into the surface.
5 OPERATION
5.1
Charging the rechargeable battery
CAUTION! Danger of fire during
charging! Due to heating of the charger, there is
a danger of fire if it is placed on an inflammable
surface and is not adequately ventilated.
■
Always use the charger on a non-inflamma-
ble surface or in a non-combustible environ-
ment.
■
If available: Keep the ventilation slots free.
1. Insert the mains plug (01/1) of the charger
(01/2) into the power socket.
2. Push the rechargeable battery (01/3) into the
rechargeable battery slot (01/4) until it engag-
es. The charging process begins.
3. When the LED (01/5) indicates that charging
has been completed (see chapter 5.2 "Status
displays on the charger", page 15):
■
Press the release button (01/7) and re-
move the rechargeable battery.
442925_a
All manuals and user guides at all-guides.com
■
Remove the mains plug from the power
socket.
5.2
Status displays on the charger
The LED (01/5) on the charger unit indicates the
charge status of the rechargeable battery:
Symbol
Explanation
(01/6)
LED lights green: The recharge-
able battery is fully charged.
LED flashes green: The recharge-
able battery is charging.
LED lights red: The rechargeable
battery is defective.
LED flashes red: The recharge-
able battery is too hot or too cold
and will therefore not charge.
6 HELP IN CASE OF MALFUNCTION
NOTE For malfunctions that are not listed
in this table or that you cannot resolve yourself,
please contact our customer service.
The rechargeable battery cannot be pushed
into the charger.
Possible
Solution
cause
Wrong char-
Charge the rechargeable bat-
ger
tery using the charger provided.
Rechargeable
Turn the rechargeable battery
battery incor-
so that the contacts of the re-
rectly posi-
chargeable battery and the
tioned.
charger are aligned.
The rechargeable battery is not charging.
LED on the
Possible
charger
cause
LED lights up
The service
permanently
life of the re-
red.
chargeable
battery has
expired.
The recharge-
able battery is
not fully in-
serted in the
charger.
Solution
Replace the
rechargeable
battery.*
Push the re-
chargeable
battery fully
into the char-
ger.
15
Publicité
