Alcad STB-050 Manuel page 22

PROGRAMMING THE STB-050
Once the IPTV receiver is installed, we can proceed with its configuration.
By default the STB-050 is shipped with a network configuration of DHCP and in interactive mode (ready
to interact with the ALCAD IPTV Solution server). Depending on the type of installation, the STB-050 will
be configured in interactive or non-interactive mode
Programming for Interactive mode installations:
With the IPTV server previously configured, turned on, and connected to the IPTV network:
• Connect the STB-050 to a switch in the IPTV network using an Ethernet cable.
• Connect the STB-050 to your TV via an HDMI cable.
• Turn on the TV.
• Turn on STB-050.
• Follow steps on screen to register the STB-050 in ALCAD IPTV Solution system with the remote control.
• Alternatively, you can register the STB-050 directing in the web interface of ALCAD IPTV Solution Manager.
After registering the STB-050, you can find out the IP of the STB-050 in the IPTV Manager. Refer to next
section for options available for additional settings.
Programming Noninteractive mode installations
As the STBs are configured by default in interactive mode, they have to be configured for waching chan-
nels. For that is important to have the ALCAD FW in a USB; FW that must be inside a folder with the
name: MAG324. Moreover, the FW must have the name: imageupdate. With that prepared:
• Connect the STB-050 to the TV by HDMI cable.
• Turn on the STB-050.
• With the remote control, press the menu button
22 - ALCAD STB-050 Manual
All manuals and user guides at all-guides.com
.
Pic. 5 –Remote Control
EN