KANGYE KYQ-U43S-B Instructions De Montage Et D'utilisation page 54

All manuals and user guides at all-guides.com
are used. Butane can be used but because of the rate of the appliance the cylinder will tend to freeze and
supply gas at reduced pressures affecting the performance of your barbecue.
Put the gas cylinder into the cylinder hole of the trolley bottom shelf when use the barbecue
NOTE FOR CONSUMER: Retain for future Reference
CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane or propane gas or LPG mixtures, fitted with
the appropriate low-pressure regulator via a flexible hose. The hose should be secured to the regulator
and the appliance with hose clips. For barbecue which set to I3B/P(30), I3+(28-30/37) should use a
regulator which operates butane gas at 30 mbar and propane gas at 37 mbar. For I3B/P(50), a regulator
operates the butane, propane gas mixture at 50mbar. Ensure the regulator was certified by standard
EN16129
Please consult your LPG dealer for information regarding a suitable regulator for the gas cylinder.
Regulator and Hose
Use only regulators and hose approved for LP Gas at the above pressures. The life expectancy of the
regulator is estimated as 2 years.
The use of the wrong regulator or hose is unsafe; always check that you have the correct items before
operating the barbecue.
The hose used must conform to the relevant standard for the country of use. The
length of the hose must be 1.5 metres (maximum). Worn or damaged hose must be
replaced. Ensure that the hose is not obstructed, kinked, or in contact with any part
of the barbecue other than at its connection.
Storage of Appliance
Storage of an appliance indoors is only permissible if the cylinder is disconnected and removed from the
appliance. When the appliance is not to be used for a period of time it should be stored in its original
packaging and stored in a dry dust free environment.
Gas Cylinder
The gas cylinder should not be dropped or handled roughly! Always keep the cylinder in upright position.
during operation. Make sure the cylinder is from any source of flame before you change the cylinder. If the
appliance is not in use, the cylinder must be disconnected. Replace the protective cap on the cylinder after
54