JBL PROPOND AUTOFOOD Mode D'emploi page 16

Parts / contents:
1. Food container with 1a storage compartment for power supply unit
and temperature sensor
2. Integrated carrying handles
3. Lid of the food container with 3a cable guide for power supply unit
and temperature sensor
4. Solar panel
5. Lid hinges with catch
6. Warning light for low food
7. Control panel cover
8. Control panel
9. Feed ejection port
10. Rain cover for 9
11. Fixing screw under each foot
12. On/off: switches JBL PROPOND® AUTOFOOD on or off
13. Pushbutton for manual feeding
14. Pushbutton for food quantity
15. Pushbutton for hour
16. Pushbutton for minute
17. Pushbutton "Set" (confirmation)
18. Symbol time
19. Symbol feeding profile ( Feed 1–Feed 24)
20. Symbol food quantity (Vol.)
21. Temperature display
22. Battery indicator
23. Time display
24. Temperature unit °C or °F
25. Symbol for solar feed-in (SOLAR)
26. Symbol for mains operation (DC)
27. Selector switch for throwing range
28. Temperature sensor
29. Power supply
30. Mesh guard screw conveyor
Installation:
1. Remove the JBL PROPOND® AUTOFOOD from its packaging and check all parts are
enclosed. The power supply unit and the temperature sensor are located in the stor-
age compartment (1a) in the food container (1).
2. Place the JBL PROPOND® AUTOFOOD on a level surface at the edge of your pond.
The rear side with the feed ejection port (9) should be max. 20 cm away from the wa-
ter. To retain the food quality, select a location away from long-term direct sunlight.
The weight of the device usually ensures its standing stability. Should you require
additional fastening, there are fixing screws M8 (11), which can be combined with
commercial flat connector plates (DIY store) etc., in the feet of the device.
8
All manuals and user guides at all-guides.com