Heath Zenith 6164 Mode D'emploi

Model 6164
This package includes (Style of push button and chime may vary from illustration):
• Wireless chime
• Wireless push button with battery
• Hardware pack
This chime requires 3 "D" alkaline batteries (not included). In typical use,
alkaline batteries will last up to three years.
Figure 1
Figure 2
Chime Volume
Figure 3
© 2008 HeathCo LLC
All manuals and user guides at all-guides.com
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notify doctor.
1. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screw-
driver (see Figure 1). See diagram inside push
button for correct battery orientation. Note: If
batteries are preinstalled, remove orange
battery tab.
2. Open chime case. Press in both catches on
the bottom of the chime and lift the case open
(see Figure 2).
3. Install 3 alkaline "D" batteries. Make sure
batteries are oriented properly (see Figure 3).
4. Test range. Temporarily position chime and
push button where you want them mounted.
Press push button to verify chime and push
button work properly. If chime does not sound,
see Troubleshooting.
5. Adjust volume control. Adjust volume control
to desired volume (see Figure 3).
Wireless Musical
Chime
595-5707-06