BELLAGIO H3OCTKTB2BSN Instructions page 6

If your heater fails to operate, please follow these procedures prior to contacting Customer Service:
Problem Probable Cause
Heater is not plugged into a
120V polarized
outlet/receptacle.
The heater fell over and the
Tip-Over Switch temporarily
shutting off the unit.
Thermal Cut-Off has
temporarily turned off the
Heater will not
heater due to high
power on.
temperatures.
Breaker/Fuse has been
tripped.
Room temperature has
Power light is been warmed up to
on, but no heat thermostat setting.
is released
The timer was set for the
from unit.
heater to turn off
automatically.
A drop of oil fell on the
heating coil during the
manufacturing process. It
will quickly evaporate and
The heater is
creating a should not occur again.
burning smell.
Check & ensure there are
no combustible materials 3
ft (0.9m) surrounding the
heater.
Unit over heats, Objects placed near the
temporarily heater preventing proper air
disabling unit. circulation.
DO NOT RETURN THE UNIT TO THE STORE OF PURCHASE. If the problem
still persists, refer to the warranty. For more information call 1-800-268-7622 for
service.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO COULD VOID
THE WARRANTY AND CAUSE DAMAGE OR PERSONAL INJURY.
H3OCTKTB2BSN
Bellagio By Airworks
TROUBLESHOOTING
Solution
Ensure unit is in OFF position. Plug in unit and attempt to
turn on again.
Turn heater off and unplug. Position heater in an upright
position and ensure the unit is on a flat and even surface.
To resume normal operation, simply plug heater back into a
properly polarized outlet.
Turn heater off and unplug. Allow it to cool for 30 minutes.
Once heater has cooled off, check to make sure there are
not objects on or very close to the unit. To resume
operation, plug unit back in once it has cooled off.
Please check your electrical box to confirm the breaker has
not been blown. This may occur if the unit is sharing a
receptacle with another high power consuming appliance.
Ensure unit is in OFF position. Plug in unit and attempt to
turn on again.
Attempt to plug unit into another independent receptacle in
the house.
To resume heating, adjust thermostat to a higher setting.
Refer to THERMOSTAT section for more information.
Turn the timer function OFF by pressing the timer button
until lights at the hour numbers are all off. For more
information, see TIMER section.
Ensure room in which heater is situated is well ventilated.
Remove the combustible units preventing air intake into the
heater.
Ensure room in which the heater is situated is well ventilated
and there is at least 3 ft (0.9m) of space between the heater
and any objects.
6