TMI VK61 Fonctionnement page 2

Method 1
1) Set the crown to the normal position
2) Touch the AC terminal of circuit block and the switch spring with conductive
tweezers to reset the circuit.
3) The small second hand will move at two-second interval for 10 seconds as a
demonstration. (VK61 only)
Method 2
1) Pull out the crown to the second click position.
2) Press the button B for two seconds and release the button.
3) Push the crown back to the normal position.
4) The small second hand will move at two-second interval for 10 seconds as a demonstration
* If the crown is operated within the 10 seconds, the two-second interval movement will not be activated
(VK61 only)
* It is not necessary to set the chronograph hands after the battery is exchanged. If the chronograph hand
positions are incorrect, follow below procedure all the chronograph hands will be reset to "0" position.
Button A
(START)
[ Standard measurement : e.g. 100m race ]
Press the buttons in the following order :
START
* Press button A to start the
chronograph. The
chronograph hands will start
moving.
* The chronograph can measure up to 60 minutes and chronograph stops after a measurement for 60 minutes.
* After the maximum measurement time finished, to restart the chronograph function :
VK61 / VK64 : Press button A
* During the chronograph operation, button B (reset) can be pushed. It will not cause any problem.
All manuals and user guides at all-guides.com
Operation Manual
VK61 / VK64
HOW TO RESET (AFTER BATTERY CHANGE)
HOW TO USE THE CHRONOGRAPH
A
STOP (Finish)
(20 minutes 10 seconds)
* Press button A again to stop
the chronograph. The
chronograph hands stop to
indicate the elapsed time.
Button A
(STOP)
A B
* Press button B to reset the
chronograph. All the
chronograph hands will be
reset to "0" position.
(VK61 only)
Button B
(RESET)
RESET
English