Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The smaller the gauge number of the wire, the greater the capacity of the cord. For example: a 14-gauge cord
can carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total
length, be sure each cord contains at least the minimum wire size required. If you are using one extension cord for
more than one tool, add the nameplate amperes and use the sum to determine the required minimum wire size.
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY RULES FOR SANDERS / POLISHERS
WARNING:
FROM REPEATED USE) REPLACE STRICT ADHERENCE TO PRODUCT SAFETY RULES. If
you use this tool unsafe or incorrectly, you can suffer serious personal injury!
Always wear safety glasses or goggles.
•
safety glasses. use certified safety equipment. Protective eye wear should comply with ANSI Z87.1 standards
Use adequate and appropriate respiratory protection.
•
products, paints and woods may expose the user to dust containing hazardous substances.
Always hold the tool firmly.
•
Use only accessories rated for at least the maximum speed as displayed on
•
the tool's nameplate.
their rated maximum speed may fly apart and cause serious personal injury.
Check the backing pad for cracks, damage or deformity
•
Immediately replace cracked, damaged, or deformed pads.
Never use this tool with wood cutting blades or other saw blades.
•
blades on the sander/polisher frequently kickback, causing loss of tool control resulting in personal injury.
Keep hands away from rotating parts
•
Before starting the tool make sure the sanding disc or polishing bonnet is
•
not contacting the workpiece
Check that the workpiece is properly supported and secured in place
•
Do not release your grip on the tool until the wheel comes to a complete
•
stop
. After switching off the tool the wheel will continue to rotate.
This tool is not waterproofed. Do not use water on the workpiece surface
•
Adequately ventilate your work area when performing sanding operations.
•
WARNING:
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFORT OR FAMILIARITY WITH PRODUCT (GAINED
Do not leave the tool running unless hand held.
Backing pads, discs, and other accessories running at speeds greater than
.
Read and understand all warnings, cautions and operating
SAVE THESE INSTRUCTIONS
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
Normal prescription eye or sunglasses are not
.
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
using this tool to sand some
before operation.
using such
.
.
5
Publicité
Table des Matières
