Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
4. INSTALLING THE BASE
Take out the tower body and tower base carefully from their box; also take out the 7 screws, speaker holder and speaker base.
Assemble the speaker base, the holder and the body with a screwdriver (not included) as per the picture below. Then put the tower
standing on the floor; now the speaker is ready for use.
5. CONNECTING TO THE POWER SOURCE
This unit was designed to operate with an AC 110-240V / 50-60Hz power supply.
Connecting this system to any other power source may cause damage to the system.
Unwind the AC power cord to its full length. Connect the main plug into a standard AC socket.
Do not plug or unplug the power cable with wet hands.
Press the button "On" in the back side of the speaker; the device is now connected and ready to use.
The unit will enter standby mode; press the "Power" button on the remote control or on the unit
to switch the unit on.
To switch the unit off completely, withdraw the power cord form the wall socket.
Please disconnect the main plug from the AC socket if the device is not going to be used for a
long period of time.
6. USING THE REMOTE CONTROL
The battery
If your remote does not work properly or you find you have to move closer the unit to operate, the
battery probably needs to be replaced.
To replace the battery, slide the holder out from the base of the remote. Remove the battery and
replace with a 3V lithium CR2025.
3
Publicité
