CHICAGO Electric 95235 Instructions D'installation page 8

to Operate the Air Blower:
1. Once the Air Blower is positioned in the desired location, make sure the Power
Switch (10) is in its "OFF" position. (See Figures C and D.)
2. Plug the Power Cord (14) of the Air Blower into the nearest 120 volt, GFCI (Ground
Fault Circuit Interrupter) electrical outlet.
Turn the Power Switch (10) to either its HIgH, MEDIUM, or LOW setting. Periodi-
3.
cally monitor the operation of the Air Blower when it is in use. (See Figure C.)
4. When finished using the Air Blower, turn the Power Switch (10) to its "OFF" position.
Then unplug the Power Cord (14) from its electrical outlet. (See Figure C.)
5. Make sure to store the Air Blower in a clean, dry, safe location out of reach of chil-
dren and other unauthorized people.
InSPECtIOn, MAIntEnAnCE, AnD CLEAnIng
CAUtIOn! Always make sure the Power Switch (10) of the Air Blower is in its "OFF"
1.
position and the unit is unplugged from its electrical outlet prior to performing any
inspection, maintenance, or cleaning procedures. (See Figure C.)
2. Before each use, inspect the general condition of the Air Blower. Check for mis-
alignment or binding of moving parts, cracked or broken parts, damaged electrical
wiring, and any other condition that may affect its safe operation. If abnormal noise
or vibration occurs, have the problem corrected before further use. Do not use
damaged equipment.
3. To clean the exterior of the Air Blower, use only a clean cloth and mild detergent.
Do not immerse any part of the unit in liquid. To clean the Impeller (15) or inside
the Housing (7), remove the Side Guard (20) by removing the Screws (21). Wipe
with a damp cloth only. Then replace the Side Guard and re-install the Screws.
(See Assy. Diagram.)
CAUtIOn! All maintenance, service, or repairs not mentioned in this manual
4.
must only be performed by a qualified service technician.
For technical questions, please call 1-800-444-3353.
SKU 95235
All manuals and user guides at all-guides.com
Page 8