jbc IN 2100 Manuel D'instructions page 4

ENGLISH
CHANGING THE TIP
Use the tip removal device Ref. 0114108.
1 Remove the ring to release the tip.
2 Remove the tip by pulling the soldering
iron lengthwise without forcing the
element.
Before fitting the new tip, clean the part
of the element which is covered by the
tip, to eliminate any contamination and
facilitate the insertion of the new tip.
All manuals and user guides at all-guides.com
3 Insert the new tip and make sure that it
TIP CARE
- To clean the tips, use the damp sponge
- Do not file the tips or use abrasive tools
- If the tip has been a long time without
JBC reserves the right to after specifications without prior
notice.
2
has penetrated fully home, otherwise its
thermic performance would be altered
and would not correspond to the
temperature reading.
included with the JBC stand. Only
deionised water (car battery watter)
should be used in order to wet the
sponge. If normal water was to be used,
it is very likely that the tip will become
dirty due to the salts dissolved within the
water.
which may damage the tip's protective
surface coating and avoid knocking them
about.
being tinned, use the metal brush
Ref. 0297705 adaptable to the support,
to remove any dirt and oxide.