Power Dynamics PDX125 Manuel D'instructions page 5

20. SINGLE / CONT BUTTON
Press this button to switch between the SINGLE and CONTINUOUS play mode. The selected mode is
indicated on the LCD. In SINGLE mode, after each track, the unit stops the reading. In CONTINUOUS mode,
the unit reads all tracks and stops.
21. MP3/CD BUTTON
By pressing this button repeatedly, you can select the playback sourceCDdrive/USB interface/SD card
reader.
22. TAP BUTTON
Press this button in the rhythm of the music. The display (17) shows the beats per minute (BPM)
23. PITCH CONTROL
Use this fader to increase/decrease the speed of the track.
24. USB PORT
Insert the USB Stick
25. SD PORT
Insert the SD Card
26. HEADPHONE JACKS
Used to connect for audio monitoring with headphones.
27. DISC HOLDER
Place the discs in the holder, press OPEN/CLOSE to open and close the disc holder.
28. CUE FOR CHANNEL 1 AND 2
Selects which source will be live to that channel for CH1 & CH2.
29. INPUT TOGGLE SWITCH
Selects which source will be live to that channel based on what you have connected to the rear panel input
section. IN CD 1-2 position the internal CD units are active.
30. CH1&2 GAIN CONTROL
Audiosignal level control
31. HIGH FADER 1&2
You can adjust the high tones of the signal
32. MID FADER 1&2
You can adjust the middle tones of the signal
33. LOW FADER 1&2
You can adjust the low tones of the signal
34. CUE LEVEL CONTROL
35. DJ MIC
You can adjust the level of the mic signal
36. INPUT FADER
Controls individual source levels for CH1&2 in the mix.
37. REPLACEABLE CROSSFADER
HIERMIT WERDEN
EINGANGSKANÄLEN. WENN DER X-FADER IN DER MITTELSTELLUNG IST WERDEN BEIDE
ZUGEORDNETEN KANÄLE LIVE.
38. FADER START
Activation allowes you to start the CD players from your x-fader . Travel from left to right will start the right
CD player and pause the left CD player.
39. LED METER
Indicates the master output level.
40. MASTER LEVEL
Adjust master level output.
41. AC CORD
42. LINE OUT
Connect to the line input of your mixer-amplifier etc.
43. LINE/PHONO INPUT SWITCH
To allow either line level or phono level equipment to be plugged into your channel inputs; when phono input
is selected, your signal is fed directly to the HQ RIAA phono pre amplifiers.Line level sources will overload
the pre amps and will sound very bad, so be sure to toggle the line/phono switch over to line in case of line
sources.
SAUBERE BLENDUNGEN ERREICHT ZWISCHEN DEN BEIDEN