Belkin TuneBase FM Manuel De L'utilisateur page 12

All manuals and user guides at all-guides.com
Troubleshooting
Issue - The audio is distorted.
Solution 1 - Decrease the TuneBase FM volume setting. Setting the volume setting to "VOL 4" or "VOL
5" increases the likelihood of audio distortion, except when using iPod nano.
Solution 2 - Make sure that your iPod nano EQ setting is "Off" or "Flat". Some EQ settings cause the
audio to clip.
Solution 3 - Tune your car stereo and the TuneBase FM to a different frequency.
Issue - The audio is too quiet.
Solution 1 - Increase the transmission volume setting. If your hear distortion in the audio, decrease
the volume setting. The default setting of "VOL 3" is ideal for most conditions.
Issue - I am unable to get clear FM reception.
Solution 1 - Tune your car stereo and the TuneBase FM to a different frequency.
Solution 2 - In some instances, lowering the car antenna (available in some cars) will improve the
clarity of the TuneBase FM's signal.
Solution 3 - Change the stereo/mono setting to mono mode. This may improve signal reception, but
the audio will be monaural instead of stereo.
Issue - iPod nano playback stays paused after I've changed a setting on the TuneBase FM.
Solution - Simply press the "Play/Pause" button on your iPod nano to resume playback.
Issue - When I remove my iPod nano from the TuneBase FM cradle or turn off my car, iPod
nano playback does not automatically pause.
Solution - If you remove the iPod nano from the TuneBase FM cradle within 12 seconds of adjusting
the TuneBase FM settings, or remove power to the TuneBase FM during this time, the iPod nano may
not automatically pause. Simply press the "Play/Pause" button on your iPod nano to pause playback.
Troubleshooting | 08
ea_F8Z063ea.indb 10 15/8/06 12:3