Segon JS-EST10 Notice D'utilisation page 6

PROTECTING YOUR OUTDOOR SPEAKER
Segon® recommends using a "drip loop" when installing your speaker cable to
help minimize the direct flow of water onto the speaker. This will assist in reducing
any potential long-term oxidation or water penetration issues by providing a low
point for water to escape prior to reaching the speaker.
The below examples illustrate how (and how not) to utilize a drip loop.
Underpower VS. Overpower
•
Most speaker damage is caused by amplifiers
with too little pow r (wattag ).
•
An overdriven amplifier clips the waveforms
and leads to speaker distortion.
•
Clipping is usually audible and it may vary
from a harsh sound to a fuzzy or unclear sound.
Volume Control
•
The volume is controlled by your amplifier.
Woofer
Impedance(AC)
Sensitiv ty( Output SPL)
Freq. Range
Power Handling RMS (Rated Input power)
Housing Material
Dimension(W*H*D)
Net Weight
Attachmen
Multi Dev ce Connection
IP Rating
With a "DRIP LOOP"
PRODUCT SPECIFICATIONS
•
If you hear the clipping at high volume levels,
turn down the volume until th distortion i
gone.
•
Damage caused by operating th speakers at
distorted volume levels is not covered by the
warranty.
3 inch*1 ( Paper cone, Foam cotton Surround
8Ω
84±3dB
228 Hz-20kHz±3dB
15W program, 10W ( IEEE 219 )
ABS
90.5*97*107.5mm
0.63 kg
Bracket, Screw
YES
IP64
Mini Satellite Loudspeaker JS-EST10