Using The Product; Thermostat Setting Button; Defrost - Beko RCNE560K40DXBN Manuel D'utilisation

5 sing the product
U

5.1. Thermostat setting button

The operating temperature is regulated by the
temperature control.
W
1=Lowest cooling setting (Warmest setting).
4=Highest cooling setting (Coldest setting).
The average temperature inside the fridge should be
around +5°C.
Please choose the setting according to the desired
temperature.
Please note that there will be different temperatures in
the cooling area.
The coldest region is immediately above the vegetable
compartment.
The interior temperature also depends on ambient
temperature, the frequency with which the door is
opened and the amount of foods kept inside.
Frequently opening the door causes the interior
temperature to rise.
For this reason, it is recommended to close the door
again as soon as possible after use.
May not be available in all models
*Optional:
C
product. If your product does not comprise the relevant parts, the information pertains to other models.
C
5
The figures in this user guide are intended as drafts and may not perfectly match your
5.2. Thermostat setting button
The interior temperature of your refrigerator changes
for the following reasons;
• Seasonal temperatures,
• Frequent opening of the door and leaving the
door open for long periods,
• Food put into the refrigerator without cooling
down to the room temperature,
• The location of the refrigerator in the room (e.g.
exposing to sunlight).
• You may adjust the varying interior tempera-
ture due to such reasons by using the thermostat.
Numbers around the thermostat button indicates the
cooling degrees.
• If the ambient temperature is higher than 32°C,
turn the thermostat button to maximum position.
• If the ambient temperature is lower than 25°C,
turn the thermostat button to minimum position.

5.3. Defrost

Fridge compartment
Fridge compartment performs full-automatic
defrosting. Water drops and a frosting up to 7-8
mm can occur on the inner rear wall of the fridge
compartment while your refrigerator cools down.
Such formation is normal as a result of the cooling
system. The frost formation is defrosted by performing
automatic defrosting with certain intervals thanks to
the automatic defrosting system of the rear wall. User
is not required to scrape the frost or remove the water
drops.
Water resulting from the defrosting passes from the
water collection groove and flows into the evaporator
through the drain pipe and evaporates here by itself.
Deep freezer compartment does not perform
automatic defrosting in order to prevent decaying of
the frozen food.
The freezer compartment defrosts automatically.
Check regularly to see if the drain pipe is clogged
or not and clear it with the stick in the hole when
necessary.
12 /35 EN
Refrigerator / User Guide