Genesis GBS321A Manuel D'utilisation page 6

Know the location and operation of the switch trigger "Lock-ON" button.
•
using the sander with the switch locked "oN", be ready for emergency situations to switch it "off".
Be sure to properly adjust the belt tracking so it doesn't overhang the tool
•
housing.
Severe lacerations can be caused by a running belt overhanging the housing.
Take precautions against dust inhalation.
•
species and wood products can be injurious to your health. Always operate your sander in a well ventilated
area and provide for proper dust removal. Dust collection systems should be used whenever possible. Wear
an approved dust mask or respirator. Splinters, airborne debris and dust can cause irritation, injury, and/or
illness.
Some wood contains preservatives which can be toxic. Take extra care to
•
prevent inhalation and skin contact when working with these materials.
for and follow any safety information available from your material supplier.
WARNING:
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
KNOWING YOUR BELT SANDER
5
8
1. Switch Trigger
2. Lock-oN Button
3. Variable Speed Dial
4. Rear Handle
5. front Handle
6. Dust Bag
Read and understand all warnings, cautions and operating
SAVE THESE INSTRUCTIONS
3
1
7. Sanding Belt
8. Belt Tracking Knob
9. Belt Tension Release Lever
10. front Pulley
11. Rear Pulley
12. Handle Lock Lever
3"x21" Variable Speed Belt Sander
Operator's Manual
The dust generated while sanding certain wood
1 2 4
11
GBS321A
6
12
9 7
FIG 1
If
Ask
10