K2 Pumps PAWP00003K Manuel D'installation

Pitcher Pump Leather Repair Kit
INSTALLATION INSTRUCTIONS
Model: PAWP00003K
Replacing the Cup Leather
Step 1. Loosen the cap screw (Key No.1) on the pump
cap (Key No.2) and lift the plunger assembly out of
the pump.
Step 2. Unscrew the cup leather holder (Key No. 4).
Step 3. Remove old cup leather (Key No. 3), and put on
new cup leather
Step 4. Screw the cup leather holder (Key No. 4) back into
original position.
Step 5. Reinstall plunger assembly and pump cap (Key
No.2).
Step 6. Insert cap screw (Key No.1) and tighten.
For Professional Technical Support call 1-844-242-2475
Copyright © 2020, GP Enterprises Co., Ltd.
3. cup
leather
7. screw
K2Man-20 (Rev. 7/01/20)
1. screw
2. pump cap
4. cup leather
holder
5. pump body
6. screws
8. check valve
9. valve leather
10.nut/washer
11. base
Replacing the Valve Leather
Step 1. Loosen the cap crews (Key No.6) located at the
base (Key No.11) of the pump body (Key No.5).
Step 2. Remove the pump body (Key No. 5) from the pump
base (Key No. 11).
Step 3. Loosen the screw (Key No.7) and remove the check
valve (Key No. 8) from the valve leather (Key No. 9).
Step 4. Remove old valve leather. Clean any old leather off
of column and base.
Step 5. Position the raised end of check valve (Key No.8) at
the attached/hinged end of valve leather (Key No.9).
Step 6. Reattach check valve (Key No.8) to the valve
leather (Key No.9) with the screw (Key No.7), nut
and washer (Key No.10).
Step 7. Position new valve leather (Key No.9) with check
valve (Key No.8) on base (Key No.11).
Step 8. Reattach pump body to the base by reinstalling and
tightening the cap screws (Key No.6).