Plantronics Vista M12 Guide D'utilisation page 12

VISTA.multiling.guide
set default
3
S T E P
1. Headset /Handset Selector is depressed
2. Mute Switch is released (no colored
3. Incoming Volume Thumbwheel is set to 4.
4. The Outgoing volume has been pre-set. You
10
All manuals and user guides at all-guides.com
11/4/98 5:55 PM Page 10
I N S T A L L A T I O N S T E P S
s e t t i n g s
These are the default settings for
headset use.
(colored indicator showing).
indicator showing).
can adjust it when you place your first call
(see page 18).
e n g l i s h
I N S T A L L A T I O N S T E P S
set telephone/amplifier
4
S T E P
C o m p a t i b i l i t y S w i t c h
1. Put on headset.
2. Lift the phone's handset off the cradle
and place it on your desk.
3. If you don't hear a dial tone, adjust the
Telephone/Amplifier Compatibility
Switch as indicated below:
1. Remove the Telephone Compatibility
Switch Access Door by placing two fin-
gers or thumbs on the raised bumps and
pushing down.
2. Remove the flat, plastic screwdriver
from the bottom of the amplifier by slid-
ing it through the braces holding it in
place.
3. Make sure the amplifier is in the default
settings, and your telephone handset is
off of its cradle.
4. Using the screwdriver, slide the
Compatibility Switch until you hear a
clear dial tone. Experimenting with vari-
ous switch settings will not harm the
amplifier or your telephone.
e n g l i s h 11