DeWalt DWHT77100-XJ Manuel De L'utilisateur page 5

Contents
• User Safety
• Battery Safety
• Setup (Load Batteries)
• Setup LDM
• Operation
• Warranty
• Error Codes
• Specifications
EU/GEM
Retain all sections of this manual for
future reference.
User Safety

WARNING: Carefully read the Safety
Instructions and Product Manual
before using this product. The person
responsible for the product must ensure
that all users understand and adhere to
these instructions.

WARNING: The following label
information is placed on your laser tool
to inform you of the laser class for your
convenience and safety.
The DWHT77100 tools emit a visible laser
beam, as shown in Figure A
emitted is Laser Class 2 per IEC 60825‑1.

WARNING: While the laser tool is in
operation, be careful not to expose your
eyes to the emitting laser beam (red
light source). Exposure to a laser beam
for an extended time period may be
hazardous to your eyes. Do not look
into the beam with optical aids.
1
. The laser beam
WARNING: To reduce the risk of
injury, user must read the Product User
manual, Laser Safety manual, and
Battery Safety information.

CAUTION: Use of controls or
adjustments or performance of
procedures other than those specified
herein may result in hazardous
radiation exposure.
Battery Safety

WARNING: Batteries can explode or
leak and cause serious injury or fire. To
reduce the risk:
• ALWAYS follow all instructions and
warnings on the battery label and package.
• DO NOT short any battery terminals.
• DO NOT charge alkaline batteries.
• DO NOT mix old and new batteries. Replace
all of them at the same time with new
batteries of the same brand and type.
• DO NOT mix battery chemistries.
• DO NOT dispose of batteries in fire.
• ALWAYS keep batteries out of reach
of children.
• ALWAYS remove batteries if the device will
not be used for several months.
NOTE: Ensure that the recommended
•
batteries are used.
NOTE: Ensure the batteries are inserted in the
correct manner, with the correct polarity.
Setup (Load Batteries)
1. Locate the battery compartment latch on
the back of the tool (Figure D
2. Using your finger, pull the latch up to
unlock and remove the battery door
1
(Figure E and
3. Insert two AAA batteries, making sure to
position the ‑ and + ends of each battery
as noted inside the battery compartment
3
(Figure E ).
2
).
2
).
E
5