IXON clim8 Guide D'utilisation page 5

SAFETY WARNINGS
AND INSTRUCTIONS
Read Do not use Do not insert
operator's folded or pins
manual rucked
Keep these important
instructions for future reference.
Please read the operating
instructions carefully.
Do not use with a helpless person,
an infant or a person insensitive
to heat.
Please consult your doctor before
using this IT-SERIES gloves if you
have problems sensing hot or cold
objects (e.g., diabetics, disabled
persons, Raynaud's, etc.).
People with a heart pacemaker,
metal implants or insulin pump
should first consult with their
doctor before using the IT-SERIES
gloves.
Excessive heat levels over pro-
longed periods can lead to burns.
Check the device regularly for
signs of wear or damage. If you
notice any of these signs, if the
device was used improperly or if
the device does not work, bring
it back to the dealer before using
it again.
8
Not suitable for children under the
age of 36 months.
The IT-SERIES gloves can be used
by children older than 3 years and
younger than 8 years under super-
vision and with the control always
set to minimum temperature value.
Children may only use the IT-SE-
RIES gloves under the supervision
of an adult.
Not intended to be used to warm
animals.
Only use the supplied charger to
charge the device. It is designed
for indoor use and must not be
exposed to humidity.
Do not wear the IT-SERIES gloves
during the charging process.
Do not insert any metal or other
objects into sockets or plugs
because this can damage the
IT-SERIES gloves.
If the charging cables or any other
parts of the IT-SERIES gloves are
damaged, discontinue the use of
the IT-SERIES gloves.
Do not modify the product or
divert it from its intended use.
Not intended for medical use in
hospitals.
Never use if inner liner is wet.
It is not recommended to use
the IT-SERIES gloves with an
avalanche transceiver.
The IT-SERIES gloves must only
be operated with the supplied
battery.
Do not sleep with your IT-SERIES
gloves while it is still switched on.
Examine the IT-SERIES gloves
frequently. Return to the supplier if
has been misused.
If the temperature sensors are
damaged, return the garment
to your local dealer prior to any
further use.
HOW TO USE THE IT-
SERIES GLOVES
FIRST USE AND CHARGING
THE BATTERIES
Important note: charge the
batteries prior to first use.
1 Plug the charger into the wall
and connect the cable to the
batteries. When charging, the
light on the charger will turn RED.
2 Once the batteries are fully
charged, the charging process
automatically ends and the
charge indicator changes back
to GREEN. Please disconnect the
batteries from the charger.
3 Open the inside pocket of the
IT-SERIES gloves and plug the
battery to the connector.
Batteries cannot be charged
when connected to the IT-SERIES
gloves.
HOW TO SWITCH AC
PLUGS:
1 Push and hold the button
next to the plug while turning the
plug slightly.
2 Remove the plug.
3 Install the correct plug by insert-
ing it slightly turned clockwise.
4 Turn the plug clockwise until
you hear a click.
IMPORTANT INSTRUCTIONS
FOR USE
Check to make sure that the
batteries are properly connected
with your IT-SERIES gloves (plug
locked into place).
Always set your IT-SERIES
gloves to your initial reference
temperature to maintain a
comfortable temperature.
Do not immerse the product.
TURN IT-SERIES GLOVES
ON/OFF:
To turn your IT-SERIES gloves on/
off, simply connect/disconnect the
batteries.
Auto-detection: gloves will only
start heating when you insert
your hands. To preserve battery,
removing your hands puts your
gloves in Stand by mode. Please
note that if your gloves are folded
(in a bag, a helmet...), they may
light up without you wanting
them to. To avoid false detections
EN
FR
9