Publicité
Les langues disponibles
Les langues disponibles
Operation (Image ③)
Notes:
It is advisable to switch off the filter system as the water circulation in the pool may affect the
robot's movement.
Remove all obstacles, e.g. ladders, from the pool before use.
If using a salt chlorine generator, ensure that the salt is dissolved completely before placing
the robot in the water.
We recommend cleaning a pool once a week based on normal use and contamination.
1.
Submerge the robot into the water slowly to allow all air to disperse. Switch the robot on at
its base. Release the retrieval cord float, place the robot horizontally into the pool and wait
until it sinks to the pool floor by itself.
2.
Adjust the length of the cord so that this is reaches the surface of the water. If the robots
stops moving due to the shape of the pool but the motor is still running, this can be rectified
using the retrieval cord.
3.
The robot automatically stops working when it is taken out of the water.
Note: Never lift the robot out of the water by its rotating nozzle. Use the carrying handle as shown
in image 3.
Cleaning and emptying the debris cartridge / filter (Image ④)
Empty the debris cartridge and clean the filters after each use. To do so, open the housing as
shown and rinse out all impurities with clean water.
Make sure that the filters and the cover are seated correctly when reassembling.
MAINTENANCE AND CARE INSTRUCTIONS
Always switch off the appliance and disconnect the mains plug before carrying out maintenance
or inspection work.
Check all the parts for signs of wear. Do not continue to use the product if you find any defects.
Only have parts replaced with original spare parts by a specialist in accordance with the
manufacturer's specifications. A lack of care and maintenance can damage the appliance.
Dangerous situations can arise. Regular maintenance helps to ensure the safety of the product
and increases its service life.
Maintenance and replacement of impeller (Image ⑤)
Part A Impeller
Maintenance and replacement of wheels (Image ⑥)
Image 6.1 main wheels, image 6.2 steering wheels
Note: Please contact Customer Services for replacement parts.
Storage
It is strongly advisable to ensure that the battery is neither fully charged or discharged if the
rechargeable battery pack is not going to be used for several weeks or is to be put away over
winter.
Unplug the mains plug from the socket and the charging cable from the external adaptor
and the robot.
Remove the robot's cover. Check that the robot is empty before storing it.
If needed, rinse the robot and accessories with clean water. Do not use any cleaning agents.
Clean and dry the robot and accessories using a damp cloth.
14
www.DEUBAXXL.de
Publicité
