monzana Poolboy 600 Manuel D'utilisation page 13

INTENDED USE
The robot is designed exclusively for cleaning commercial pools, salt water pools and SPAs with a
level, flat floor. The robot is intended for vacuuming loose dirt particles and debris from the bottom
of the pool and not for removing adherent debris. Only use the robot in a water-filled pool, with
a minimum water depth of 45cm and a maximum water depth of 300cm.
Use the product only for the purpose it is intended for. The manufacturer accepts no liability for
damage caused by unintended use. Any modification to the product may negatively impact safety,
cause hazards and invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product.
After unpacking, please check the product for damage and to ensure it is complete. Subsequent
complaints cannot be accepted.
PARTS LIST (Image ①)
Float
Cover
Rotating nozzle
HEPA filter
HOW IT WORKS
The top of the robot has a rotating nozzle for propulsion.
The sucked-in dirty water is first cleaned by means of the filters and is then released by the nozzle
outlet, resulting in the robot's movement.
As soon as the robot encounters an obstacle, the nozzle automatically rotates 180 degrees,
enabling the robot to continue moving. This intelligent navigation system ensures optimal surface
area coverage.
COMMISSIONING
Charging the rechargeable battery pack (Image ②)
A: On/off switch; B: Charging socket; C: Protective cap; D: Charging cable
Ensure that the robot is switched off before charging and that the charging ports are clean and
dry before proceeding.
Warning: Only charge away from the pool!
Remove the protective cap from the socket.

Connect the robot with the charger and the power connection to charge the battery.

Fully charge the robot before using it for the first time. Normally, the robot can be operated

for up to 70 minutes after being fully charged.
Factors such as water temperature and pollution level can have a major impact on battery
life.
Note: As soon as the robot starts charging, the charging indicator light on the external
adaptor turns red. When the robot is fully charged, the charging indicator light turns green.
Remove the charger adapter from the socket and close the opening with the protective cap.

NO.
A
B
B-1
C
13
Filter
Base
Charging unit
NO.
D
E
F
www.DEUBAXXL.de