Adjusting The Chain Lubrication - Makita DUC302Z Manuel D'instruction

CAUTION:
• Should the saw chain not come to a stop within
one second when this test is performed, the saw
must not be used. Consult a MAKITA specialist
repair shop.

Adjusting the chain lubrication

► 1. Adjusting screw
You can adjust the oil pump feed rate with the adjusting
screw. The amount of oil can be adjusted using the
universal wrench.
Carabiner (rope attachment point)
Carabiner (Rope attachment point) is for use of tool
hanging. Before using carabiner, pull it out and tie it with
a rope.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Removing or installing saw chain
CAUTION:
• Always wear gloves when installing or removing
the saw chain.
• The saw chain and the guide bar are still hot just
after the operation. Let them cool down enough
before carrying out any work on the tool.
To remove the saw chain, perform the following steps:
1. Press and fully open the lever until it stops.
1
1
► 1. Sprocket cover 2. Lever
2. Turn the adjusting dial to "-" direction to release
the saw chain tension.
► 1. Adjusting dial
3. Turn the lever counterclockwise to loosen the
sprocket cover until it comes off.
4. Remove the sprocket cover.
5. Remove the saw chain and guide bar from the
chain saw.
To install the saw chain, perform the following steps:
6. Make sure the direction of the chain. The arrow
mark on the chain shows the direction of the
chain.
9 ENGLISH
1
2