Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Installing the Kegerator
FIG. G
20
PRKB24C01AG & PRKB24C01AS-OD Use, Care, and Installation Guide
Diagonal
FIG. F
Silicone washer
FIG. H
10. Attach the opposite end of the gas line with the
pre-installed threaded nut to the keg coupler
(FIG. G). Tighten using the included wrench.
NOTE: Make sure the clear silicone check valve is
inside the keg coupler before attaching the gas
line. See page 14 for reference.
11. Place a silicone washer on top of the keg
coupler and connect the threaded nut from the
beer line to the coupler (FIG. H). Tighten using
the included wrench.
12. Tap the keg by pulling the keg coupler handle
outwards - away from the keg coupler and
pushing it down to lock it into position (FIG. I).
Listen for the "click" of the pull handle when
it shifts into the final downward position and
your keg will be tapped.
NOTE: The keg needs to be tapped to fit in the
kegerator, otherwise the keg coupler handle will be
too high and will prevent the keg from fitting.
P R E S R V ™
K E G E R ATO R &
B E V E R A G E C O O L E R
I N D O O R & O U T D O O R
FIG. I
Publicité
