Home Position Adjust - iSolution IM 575 SP Guide D'utilisation

Gobo1 focus Adjust
Press the MENU button up to when the
button, the unit will focus on tilt 135° , and then the unit will first focus on tilt 45° , pan 0° , pan
90° , pan 180° , pan 270° each time your press ENTER button. Use DOWN and UP button to
adjust fixable gobo wheel focus. To go back to the functions press the MENU button again.
Gobo2 focus Adjust
Press the MENU button up to when the
button, the unit will focus on tilt 135° , and then the unit will first focus on tilt 45° , pan 0° , pan
90° , pan 180° , pan 270° each time your press ENTER button. Use DOWN and UP button to
adjust rotating gobo wheel focus. To go back to the functions press the MENU button again.
Self-Test
Press the MENU button up to when the
button and the unit will run self-test by built-in program. To go back to the functions press the
MENU button again.
Ambient temperature of lamp
Press the MENU button up to when the
button and the ambient temperature of lamp will show on the display. To go back to the
functions press the MENU button again.
Fixture Hours
Press the MENU button up to when the
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button again.
Lamp ON/OFF
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to select the
or (Lamp off) mode. Once the mode has been selected, press the ENTER button to
setup or automatically return to the main functions without any change after 8 seconds. To
go back to the functions without any change press the MENU button again.
Power ON/OFF
Press the MENU button up to when the
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
(Lamp on)
is blinking on the display. Pressing
36
ENTER button and the display will blink. Use DOWN and UP button to select the
(power on) or (power off) mode. Once the mode has been selected, press the
ENTER button to setup or automatically return to the main functions without any change
after 8 seconds. To go back to the functions without any change press the MENU button
again.
Reset
Press the MENU button up to when the
button and all channels of the unit will return to their standard position. To go back to the
functions press the MENU button again.
DMX RESET :
Set DMX value of channel 16 to 200~209, then all channels of the unit will return to their
standard home position after about 5 seconds.

4.3 Home Position Adjust

Press MENU button for at least 5 seconds into offset mode to adjust the home position,
when you want to adjust gobo and color home position, you should be run
first , the functions are shown below:
Pan offset
Press the MENU button for at least 5 seconds into offset mode, use DOWN and UP button
up to when the is shown on the display. Pressing ENTER button and the display
will blink. Use DOWN and UP button to adjust the pan home position. Once the position has
been selected, press the ENTER button to setup or automatically return to the offset
functions without any change press the MENU button again, To go back to the main
is blinking on the display. Pressing ENTER
37
mode