Publicité
Les langues disponibles
Les langues disponibles
3
TEST INSTALLED FAUCET
• Remove AERATOR.
• With handle in OFF position, turn on water supplies
and checkall connections for leaks.
4
SERVICE
• To change direction of handle rotation, proceed as follows:
• Turn valve to OFF position.
• Remove HANDLE and BONNET NUT.
• Remove SPRING CLIP.
• Lift STOP WASHER, turn 90° and replace.
• Replace SPRING CLIP.
• Replace BONNET NUT, HANDLE, SCREW, and INDEX.
• AERATOR may accumulate dirt causing distorted and
reduced water flow. Remove AERATOR and rinse clean.
• If spout drips, operate handles several times from OFF to ONposition. Do not force - handles turn only 90°.
• Plastic SCREEN in CARTRIDGE may accumulate dirt causing reduced water flow. To clean, first turn off hot
and cold water supplies, then:
• Remove HANDLE and BONNET NUT.
• Remove CARTRIDGE by pulling up.
• Thoroughly rinse plastic SCREEN at base of CARTRIDGE.
• Replace CARTRIDGE until flange is tight against valve body.
• Turn valves OFF.
• Replace BONNET NUT, HANDLE, SCREW and INDEX.
• Operate both handles to flush water lines thoroughly.
Check spout mounting and hose connections for leaks.
• Operate LIFT ROD and check DRAIN for leaks.
• Turn handles into OFF position and replace AERATOR.
STOP
WASHER
CARTRIDGE
SCREEN
- 2 -
90°
SPRING
CLIP
60185 Rev. 1.9 (8/20)
Publicité
