JVC RA-F230W Manuel D'instructions page 32

Press BAND once to enter the AM radio mode.
2.
The default AM radio frequency is 522 kHz.

Repeatedly press BAND to select the desired radio band.
3.
Adjust the volume by repeatedly pressing VOLUME
4.
Repeatedly press TUNING
5.
• Press and hold TUNING
the button, the unit will scan the frequencies until a broadcasting station
strong enough for good reception is found.
NOTE:

For the best FM reception, extend the FM aerial to its full length.

For the best AM reception, rotate the unit to the position giving best
reception.
PRESETTING YOUR FAVOURITE RADIO STATIONS
Up to 10 FM and 10 AM radio stations can be preset.
1. Follow steps in "RADIO OPERATION" and tune into the station that you wish to
preset.
Press and hold SET for about 2 seconds, "P01" will flash
2.
on the display.
Press SET again to store the station.
3.
4. Repeat steps 1 to 3 to store desired stations.
To listen to preset radio stations, press MEM repeatedly to select the desired
5.
radio station.
DUAL ALARMS OPERATION
Before setting the alarm time, make sure the Clock has been set.
SETTING ALARM 1 or ALARM 2
In standby mode, press and hold AL1 / AL2 for 2 seconds.
1.
• The hour and minute digits will flash.
2. While the hour and minute digits are flashing, set the alarm time by repeatedly pressing
HR and MIN respectively.
• Press and hold HR and MIN respectively for fast advance.
Repeatedly press AL1 / AL2 to set the alarm to wake to buzzer or radio.
3.
• The corresponding indicator light(s) will illuminate on the display.
CHECKING ALARM TIME
Press and hold AL1 / AL2 for 2 seconds, the alarm time will flash on the display.
/
to tune into the desired station.
/
for about 2 seconds and then release
EN-4
/
.