Maintenance, Cleaning, And Storage - Guardian 10010 Manuel D'instructions

English
Compatibility
When making connections,
possibility of roll-out. Roll-out occurs when
interference between a connector and the
attachment point causes the connector gate to
unintentionally open and release.
All connections must be selected and deemed
compatible with the harness by a Competent
Person.
All connector gates must be self-closing, self-
locking, and withstand a minimum load of
3,600 lb (16 kN).
See Diagram A on page 9.
Limitations
Fall Clearance: There must be sufficient
clearance below the work surface to arrest a
fall before the user strikes the ground or an
obstruction. When calculating fall clearance,
account for a MINIMUM 2' (0,6 m) safety factor,
deceleration distance, user height, length of
lanyard/SRL, harness stretch, free fall, and all
other applicable factors.
See Guardian Fall Clearance Calculator:
https://guardianfall.com/digital-resources/
fall-clearance-calculator
Swing Falls: Prior to installation or use, make
considerations for eliminating or minimising all
swing fall hazards. Swing falls occur when the
anchor is not directly above the location where
a fall occurs. Always work as close to in line
with the anchor point as possible. Swing falls
significantly increase the likelihood of serious
injury or death in the event of a fall.
Maintenance, Cleaning,
and Storage
eliminate all
Cleaning after use is important for maintaining
the safety and longevity of the SRL. Remove
all dirt, corrosives, and contaminants from the
harness before and after each use. If SRL cannot
be cleaned with plain water, use mild soap and
water, then rinse and wipe dry. NEVER clean SRL
with corrosive substances.
When not in use or during transport, store
equipment where it will not be affected by heat,
light, excessive moisture, chemicals, or other
degrading elements.
3