Publicité
Les langues disponibles
Les langues disponibles
2. Open the cases and locate the jumpers on both the doorbell button and
chime (See illustration).
3. The doorbell button and chime both have eight different jumper locations.
The jumper positions 1 through 7 are used for setting the code.
4. To change the code, add and/or remove jumpers as needed. There are
128 different combinations. It is recommended to only change one jumper
at a time and then check to see if system is functioning properly. Note:
Jumpers in positions 1 through 7 must be exactly the same for both the
doorbell button and chime for this system to function.
Your Heath/Zenith wireless doorbell has 3 different selectable tunes: Ding
(one note), Ding-Dong (two note), or Westminster (eight note). The factory
setting is for the Westminster; however, this can be changed by following the
instructions below.
• Ding (one note tune)
Doorbell button: Add a jumper to location 8.
• Ding-Dong (two note tune)
Doorbell button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
• Westminster (Eight note tune)
Doorbell button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: Model 6167 has doorbell buttons for both front and back door. The
back door must use the Ding tune and the front door may use either the
Ding-Dong or Westminster tune.
Remove screw to
open access door
595-5494-09
Tune Settings
Doorbell Button Battery Replacement
Install an alkaline type A23 12 Volt bat-
tery. The positive terminal should be po-
sitioned as shown.
Back of
Chime
Tune
Setting
Inside
Doorbell
Button
-3-
* Code Settings 1-7
Must Match Both
Doorbell Button
and Chime
Publicité
