Uline H-10357 Instructions D'assemblage page 5

L-DESK RETURN AND ADJUSTABLE HEIGHT BASE ASSEMBLY CONTINUED
3. Carefully flip over the base. Insert top support
brackets (8) into ends of center frame (9). Attach
each bracket with two M6 x 10 mm bolts (N).
(See Figure 8)
NOTE: Steel lip with four holes on top support
bracket should be facing down.
Figure 8
8
4. Place return desktop (4) on a smooth, non-marring
surface to prevent scratching. Holes in the return
desktop should be facing up. (See Figure 9)
Figure 9
PAGE 5 OF 33
N
9
8
4
5. Place base on top of return desktop with brackets
extending from lifting columns facing the grommet
hole. Determine whether L-desk will be set up for
right-hand or left-hand configuration. This will impact
whether the set of holes in the left or right side of
return desktop will be used to attach the base.
(See Figure 10)
NOTE: For left-hand configuration, top support
brackets should be aligned with set of holes on
left side of return desktop. (See Figure 10)
NOTE: For right-hand configuration, top support
brackets should be aligned with set of holes on
right side of return desktop. (See Figure 10)
Figure 10
6. Insert 10 M6 x 16 mm bolts (M) and tighten to attach
top support brackets (8) and center frame (9) to
return desktop (4). (See Figure 11)
NOTE: Assembly of a right-hand L-desk is shown
in the following figures.
NOTE: Brackets extending from lifting columns
should face edge of the return desktop with
grommet hole.
Figure 11
M
Left-hand
configuration
Right-hand
configuration
Brackets
9
4
0223 IH-10357
8