Uline H-10357 Instructions D'assemblage page 10

LOCKING OPERATION
• To lock the desk, press the "M" button to display "
• To unlock the desk, press and hold the "M" button for 10 seconds while "
shows numbers, the desk is unlocked.
RESET
• If the desk is not operating normally or the handset reports an error (
• Lower desk until it reaches it's lowest height. Press and hold the down button until "
Release the down button.
• Press and hold the down button until the desk reaches its lowest height, slightly raises, then stops.
• The handset should display the height. It is now ready to use.
Desk does not go up or down.
Desk goes in the opposite direction when
pressing the up or down button.
Columns do not go up evenly.
E01
Displays –
PAGE 10 OF 33
OPERATION CONTINUED
TROUBLESHOOTING
OPERATING ISSUE
E13
on handset
S-
". Hold the "M" button for 10 seconds until "
E01 – E13
RECOMMENDATIONS
Ensure there are no obstacles in the desk's height
adjustment path, and ensure the desk is not
touching any walls.
Ensure all cords are at the appropriate length to
accommodate changes in height.
Check all connections. Ensure all motor cables
are plugged into control box.
Ensure power cord is plugged into control box and
a power outlet.
Unplug the power cord for one minute, plug back
in, and follow the reset process below:
• Ensure the handset displays digits before
attempting a reset.
• Press and hold the down button until
flashes on the display. Release the down
button.
• Press and hold the down button until the desk
reaches its lowest height, slightly raises, then
stops.
• The handset should display the height.
It is now ready to use.
If problem persists, switch motor cables at control
box and attempt another reset.
LOC
LOC
" is displayed. Once the display
), it may need to be reset.
RST
" flashes on the display.
" is displayed.
RST
0223 IH-10357