Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To set the desired temperature (Fig 7):
Press the
button (the current set temperature is now displayed).
Then press the
Finally press the
more buttons are pressed within 10 seconds then the display will once more
show the current internal temperature of the unit.
Fig 7.
Cleaning Routine:
Wash the drip tray daily, or when full.
Clean the interior of the machine whenever a used pack is replaced.
The dispense valve assembly can be completely immersed in warm soapy
water for cleaning whenever convenient.
The top and bottom hinges should be regularly cleaned using warm soapy
water applied with an appropriate cleaning brush.
The door seal is a sealed section and as such requires no cleaning. However
the area behind the seal should be cleaned regularly with warm soapy water,
and thoroughly dried. Drainage holes are provided to facilitate this.
The exterior of the machine may be wiped with a damp cloth and buff dried.
English
Thermostat Adjustment
or
button to modify the displayed value.
button to store the value and exit the adjustment. If no
Cleaning & Maintenance
05
Publicité
Table des Matières
