Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
PROBLEM:
Is there adequate
Burner flame is
gas supply?
low.
Is the supply hose bent or kinked?
YES
Straighten hose
PROBLEM:
Is there adequate
Emitter glow is
gas supply?
uneven.
Is the heater level?
YES
YES
Is the lower screen cone tilted?
Loosen but don't remove screws at top of
YES
safety valve cylinder, level, retighten
Check the burner and orifices for
blockage, see page 15
Note: It is normal for the bottom 1/2
18
Fill LP cylinder
YES
Is the control knob in the full "on"
position? (all the way counter
YES
"
to 1
"
of the emitter not to glow.
In addition, the section of the emitter above the valve panel may
also glow less than the rest of the emitter.
NO
NO
NO
NO
NO
clockwise)?
Fill LP cylinder
Level heater
Clean burner
see page 15.
Publicité
Table des Matières
