Draw-Tite 75095 Instructions D'installation

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 01131-066
Wrenches: 12mm, 19mm & 7/8"
Drill Bits: NONE
Other: Phillip's Screwdriver
Existing weld-nut
Frame rail
Fascia support bracket
Depending on vehicle
7 8
configuration use
one or the other.
LONG
Qty.
M12 x 1.25 x 40mm CL10.9 Hex Bolt
1
(1)
Qty.
1/2"-13 x 1-3/4" GR8 Carriage Bolt
3
(1)
Qty.
5
1/2"-13 Hex Nut
(1)
Qty.
7
9/16" Hardened Flat Washer
(1)
Tighten all existing OEM M14 fasteners with torque wrench to 80 Lb.-Ft (108 N*M).
Tighten all M14 CL10.9 fasteners with torque wrench to 148 Lb.-Ft (201 N*M).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
z
2006 Cequent Towing Products
Installation Instructions
Toyota Landcruiser
Fascia
Access hole
Crossmember
(3) places.
6
2 1
Lexus LX470
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV6
Tie-down bracket,
(from passenger side).
Tow hook
M14 x 1.50 x 56mm hex bolts, (short).
Existing OEM bolts; M14 x 1.50 x 63mm hex bolts, (long).
Qty.
½" Conical Washer
2
(2)
Qty.
1/4" x 1-1/2" x 2" Block
4
(1)
Qty.
6
M14 x 1.50 x 45mm CL10.9 Hex Bolt
(1)
Qty.
8
9/16" Lock Washer
(1)
Tighten all 1/2" GR8 fasteners with torque wrench to 110 Lb.-Ft (149 N*M).
Tighten all M12 CL10.9 fasteners with torque wrench to 130 Lb.-Ft (176 N*M).
Sheet 1 of 6
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
6000 (2724kg)
5000 (2270kg)
3 4
2 5
Existing weldnut, (2) places.
Existing fastener, typical both sides.
Existing bolt, (6) places.
Tie-down bracket, (from driver's side).
SHORT
Existing OEM bolts;
N75095 01-30-06
75095
87409
44546
Max Tongue
WT (LB)
750 (341kg)
500 (227kg)
Rev. A