Bestgreen CYHT09B-610 Mode D'emploi page 37

pass the cable over the hedge; it is likely to be caught by the blades. It is possible to cut
branches up to a maximum thickness of 28 mm. In order to approach branches with the
blades, move the hedge trimmer forwards straight along the line of the cut. Cut the sides of
the hedge first, then the top. In order to obtain a perfect shape, we recommend you cut
upwards in the direction of the growth. If you cut from top to bottom, the thinner branches will
move outwards leaving holes or less bushy places.
In order to cut the top in a straight line, stretch a wire along the entire length of the hedge at
the desired height.
T
ake care not to cut foreign objects such as metal wires, latticework which would be likely to
damage the blades or the drive.
I
f the blades are jammed or blocked by an obstacle, switch off the appliance immediately and
unplug it, and only then can you intervene to free the appliance.
R
otary handle use
T
- o facilitate the use of hedge trimmers in vertical sections, the rear handle is adjustable to
0 0
45 and 90 to the right and left.
H
- andle position should be adjusted only when appliance is off and disconnected
from mains.
U
- se your thumb, pull holding the lock button rearward to unlock the handle and rotate to
the right or to the left to tilt chosen
T
ips for using hedge trimmer
D
- o not use in the rain
C
- ut preferably starting with the parts closest to the power supply, by moving away slowly.
W
- hen cutting, make sure that the extension cord is always drawn behind you the side
already done.
S
- tart the trimmer before being in contact with the plant to prevent the blade being blocked.
F
- or hedge trimmer, alternately using the two sides of the blade.
F
- or efficiency, tilt the blade about 10 degrees without poking the tip of the trimmer.
F
- or horizontal areas, go from the inside to the edge of the fence to cut down the branches
on the ground.
I
- f the height of the hedge is excessive, making several passes. Between each size, cut
large branches with pruning shears or a lopper.
W
- ork carefully nearby fences to avoid blocking the blade.
GB
9