Instruction For Using The Luma Active; Using The Button; Charging The Battery - Luma ACTIVE Mode D'emploi

12
INSTRUCTIONS FOR
USING THE LUMA ACTIVE
SINGLE BUTTON
The LUMA ACTIVE is controlled via a single button. Learn more about it in
the videos which you can find in the Technology section on our website
http://luma-enlite.com.

USING THE BUTTON

Turn on/off: Press until the lights are turned on or off. When turned
off, the front lights flash three times
Switch back lights: Press for 1-2 seconds, the front lights flash
three times to confirm. The following back light modes are possible:
Permanent light – flashing light – no back light
To switch the front light mode: Press for < 1 second. The following
light modes are possible: Low beam weak – Low beam strong – Low
and high beam

CHARGING THE BATTERY

To charge the battery of the LUMA ACTIVE LED system, connect it via
a micro USB plug with an USB charging cable. It is not necessary to
remove the LED system from the LUMA ACTIVE textile while charging.
Opening is on the inside of the textile. You can either use an existing
charger of your smartphone or of another device with a micro USB
plug or you connect your LUMA ACTIVE via the supplied USB cable
to a running device which provides a USB port. Please make sure
that the used charging device corresponds to the requirements
described in the "Warnings and Safety Instructions" section.