weasy SW6 Manuel D'utilisation page 4

must always be taken to prevent the risk of fire, electric
shock and/or injury in the event of misuse.
• Make sure that the voltage rating on the
typeplate corresponds to your main voltage
of your installation. If this is not the case, contact the
dealer and do not connect the unit
• Never leave the unit unattended while in operation.
• Never open the appliance from the front, always
position yourself slightly to the side to avoid burning
yourself with steam.
• Cleaning and maintenance should not be carried
out by children unless they are at least 8 years of age
and are supervised by an adult.
SPECIAL SAFETY INSTRUCTIONS FOR THE KETTLE
• Use only cold water when filling the device.
• The water level must be between the MAX. and MIN.
marks.
• Switch the kettle off before removing it from the base.
• Always ensure that the lid is tightly closed.
• The base and exterior of the kettle must not become wet.
• Kettle body used must match with the kettle base.
FIRST USE OF THE KETTLE
• Before using the kettle for the first time, fill the kettle with cold water and boiled it twice without
any additives.
1. Fill the kettle with water. Do not overfill. Use the water level indicator.
2. Place the kettle on the base.
3. Electrical connection
• Check whether the electrical voltage which you intend to use is the same as that of the
kettle. Details can be found on the label on the base of the kettle.
• Only connect the kettle to a properly installed 220-240V 50/60Hz socket.
4. Switch the kettle to position '1'. The control lamp on the water indicator shows that the water
is being boiled.