Winplus 689101 Directives D'utilisation Et D'entretien page 9

4. Hang the Power Station onto the
mounting plate.
Note: Mounting the power station onto
drywall, plaster or masonry may require
additional screws and anchors (not
included).
Mounting on pegboard
1. Find a suitable indoor pegboard
location to mount the power station
2. Push the pegboard anchors to desired
locations on pegboard, for the four
corners of mounting plate. Then use
the screw driver to secure the
mounting plate on the pegboard with
4 pegboard screws. Do not over-
tighten the screws - snug tight only.
3. Hang the Power Station onto the
mounting plate.
9