Troubleshooting; Troubleshooting Guide - Burndy PATRIOT 81KFT Serie Instructions De Maintenance

TROUBLESHOOTING

Do not attempt to perform repairs on this tool, as specialized tools, training, and/or procedures may be required.
Should you have any problems or questions with your BURNDY
Technical Service Departments by calling 1-800-346-4175 or the BURNDY
repair related questions at 1-800-426-8720.

TROUBLESHOOTING GUIDE

SYMPTOM/PROBLEM
Ram does not advance
when activation trigger is
pressed.
Ram does not fully extend to
head closure.
Excessive or unusual noise
from tool.
Oil leaks from tool.
Number of crimps per
charge decreases with each
battery recharge.
Tool will not stop running
after activation trigger is
released.
For further assistance, contact the BURNDY
CAUSE
- Battery is not charged.
- Ram release trigger/valve is
being held open.
- Pump is damaged.
- Activation trigger switch
failure.
- Hydraulic system failure.
- Mechanical vibrations.
- Cavitation due to cold hydraulic
fluid.
- Cavitation due to hot hydraulic
fluid.
- Seal defect or mechanical
problems.
- Battery is too warm due to
frequent discharge/recharge
cycling.
- Activation trigger stuck.
- Switch failure.
Tool Service Center at 1-800-426-8720.
®
tool, please contact the BURNDY
®
Tool Service Center for tool servicing and
®
REMEDY
- Charge the battery according to the
battery charger instruction
manual provided with your tool.
- Press and release the ram release
trigger to reset the valve.
- Return to factory for repair.
- Return to factory for repair.
- Return to factory for repair.
- Return to factory for repair.
- Allow tool to warm up before use.
- Allow tool to cool before continuing
use.
- Return to factory for repair.
- Allow battery to cool to room
temperature before recharging.
- Alternate batteries often.
- Remove Battery and Check for
contaminants around the trigger
switch area.
- Remove battery and return to
factory for repair.
9
Customer &
®