Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
18
2.1–3.4
18
3.5–5.0
5.1–7.0
18
7.1–12.0
18
14
12.1–16.0
12
16.1–20.0
SPECIFIC SAFETY rULES FOr COrDLESS SCISSOrS
WArNING:
(GAINED FROM REPEATED USE) REPLACE STRICT ADHERENCE TO PRODUCT
SAFETY rULES. If you use this tool unsafe or incorrectly, you can suffer serious
personal injury!
• Be aware that this tool is always in an operating condition, because it does not have to be
plugged into an electric outlet.
• Do not force the scissors through the material, allow the scissors to cut.
• Make sure to use the proper cutting head depending on the material being cut:
*
55° cutting head for soft materials, such as cloth, thin cardboard, and EVA foam.
*
75° cutting head for hard materials, such as thin metal sheets (tin, brass, copper), plastic sheets, thick
cardboard, and clamshell packaging.
• Wear eye protection. Always use safety glasses with side shields. Use only certified eye protection
equipment marked to comply with ANSI z87.1 standards.
• Do not place battery tools near fire or heat. This will reduce the risk of explosion and possibly
personal injury.
WArNING:
you do not want cut
IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER &
BATTErY
• Save these Instructions. This manual contains important safety and operating instructions for your
battery charger.
• Before using the battery charger, read all instructions and cautionary markings on (1) Battery
Charger, (2) Battery, and (3) Product using battery.
• Use only the charger which accompanied your product or direct replacements as listed in this manual.
Do not substitute any other charger.
• Do not recharge the battery in damp or wet environments. Do not expose the battery pack to
water or rain.
• Do not operate the charger with damaged cord or plug. Replace immediately.
• Do not operate a charger if it has received a sharp blow, been dropped or otherwise
damaged in any way. Take it to a qualified serviceman.
• Do not disassemble a charger or a battery pack. Take it to a qualified serviceman when service
or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
• Do not charge the battery pack when temperature is below 50 °f (10 °C) or above 104 °f (40°C).
Store the tool and battery pack in a location where temperature will not exceed 122 °f (50 °C). This is
important to prevent serious damage to the battery cells.
• Place the charger on a flat non-flammable surface and away from flammable materials when
re-charging the battery pack.
• To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance
or cleaning.
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFORT OR FAMILIARITY WITH THE PRODUCT
Pinch hazard - Do not place fingers or other objects in blades that
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
5
Publicité
Table des Matières
