Extension Cords - Genesis GLSS08B Manuel D'utilisation

• Use recommended accessories. Using accessories and attachments not recommended by the
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury
to the user. Consult the operator's manual for recommended accessories.
• Never leave the tool running unattended, turn the power off. Do not leave the tool until it
comes to a complete stop.
BATTERY TOOL USE AND CARE
• Ensure the switch trigger is in the off position before inserting battery pack. Inserting
the battery pack into a power tool that have the switch on invites accidents.
• recharge only with the charger specified by the manufacturer. A charger that is suitable for
one type of battery pack may create a risk of fire when used with another battery pack.
• Use battery tools only with specified battery packs. Use of any other battery packs may create
a risk of injury and fire.
• Avoid storing the battery pack in a container with other metal objects such as nails,
coins, clips, keys, screws, or other small metal objects that can make a connection
from one terminal to another. Always protect the battery terminals when battery pack is not being
used. Connecting the battery terminals together may cause burns or a fire.
• Under abusive conditions, liquid may be ejected from the battery. Avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected
from the battery may cause irritation or burns.
• Battery tools do not need to be plugged into an electrical outlet, therefore, they are always
in operation condition. Be aware of possible hazards when not using your battery tool or when changing
accessories. following this rule will reduce the risk of electric shock, fire or personal injury.
SERVICE
• Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
• Service your power tool periodically. When cleaning a tool, be careful not to disassemble any
portion of the tool since internal wires may be misplaced or pinched.
WArNING:
OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious personal injury.

EXTENSION COrDS

Grounded tools require a three wire extension cord
either a two or three wire extension cord. As the distance from the power supply outlet increases, you must use a
heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage,
resulting in loss of power and possible tool damage. Refer to the table shown below to determine the required
minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a 14-gauge cord
can carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total
length, be sure each cord contains at least the minimum wire size required. If you are using one extension cord
for more than one tool, add the nameplate amperes and use the sum to determine the required minimum wire
size.
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
4
rEAD AND UNDErSTAND ALL WArNINGS, CAUTIONS AND
SAVE THESE INSTRUCTIONS
8V Cordless Power Scissors
Operator's Manual
.
Double insulated tools can use
GLSS08B