Danze D465002 Installation

Personal shower with 24" mounting bar
Ducha de mano con barra de montaje de 24".
Douche personnelle avec barre de montage de 61 cm (24 po).
• Tools Required/Outils Requis/Herramientas Necesarias:
Flathead Screwdriver/Tournevis á lame plate/Destornillador chato
Phillips Screwdriver/Tournevis Phillips/Destornillador cruciforme
Marking Pencil/Marqueur/Lápiz marcador
Level/Niveau/Nivel
Drill/Perceuse/Taladro
• Hardware Provided/Petit matériel de fixation fourni/Se incluye los herrajes:
Mounting Screw/Vis de fixation/Tornillo de montaje
Plastic Anchor/Vis d'ancrage en plastique/Sujetador de plástico
Plumber's tape/Ruban pour tuyau/Cinta de plomero
Hex wrench/Clé hexagonale/Llave hexagonal
• Installation Steps :
This product is packaged partially assembled, you will need to take some components apart to install.
INSTALL TOP SLIDE BAR POST:
1. Remove base from slide bar posts
2. Locate where you want to install the slide bar. It should be mounted
3. Using the drill bit, carefully drill the four holes. TIP: INSTALL ONE POST, THEN ASSEMBLE SLIDE BAR
CONFIRM HOLE POSITION OF SECOND POST BEFORE DRILLING
4. Insert the plastic wall anchors into the four holes. You may need to lightly tap them into
position with a hammer
5. Secure post with screws provided
6. Slide the base back onto the post, it should "click" into place. Tighten the set screw with supplied
hex wrench .
(Fig 6)
INSTALL BOTTOM POST AND SLIDE BAR
7. Hold the bar into top post, making sure the notch in the post aligns with the groove in the bar.
Repeat step 5-6 for bottom post
EXISTING INSTALLATIONS: TO INSTALL HOSE TO YOUR EXISTING SHOWER ARM
8. Remove existing showerhead. Unscrew it by turning it counter-clockwise
9. Wrap the threads on existing showerarm clockwise with plumber's tape (included). Install the
Diverter to existing showerarm by turning the Diverter clockwise
10. Re-install the original showerhead to Diverter
11. Attach hose end to Diverter
12. Test for leaks, tighten as necessary and enjoy
NEW INSTALLATIONS: WALL MOUNTED HOSE CONNECTION
8. Apply the silicone sealant to the threads of the fixture before threading onto the threaded
1/2"-14NPT pipe. Install and tighten the wall mount hose connector by turning it clockwise,
making sure that the other end point down and the face of hose connector is flush with the
finished wall surface
(Fig 8-B)
9. Attach hose end to wall mount connector
10. Test for leaks, tighten as necessary and enjoy
.
(Fig 1)
.
(Fig 4)
.
(Fig 5)
.
(Fig 7)
(Fig 10-A)
.
(Fig 11-A)
(Fig 12-A)
.
.
(Fig 9-B)
(Fig 10-B)
I N S T A L L A T I O N
.
(Fig 2)
.
(Fig 3)
.
(Fig 8-A)
.
(Fig 9-A)
.
.
.
D465002-D465003
Fig 1
Fig 2
Fig 3
Fig 4