hestan GABR Serie Installation Et Fonctionnement page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

LOCATING AND ASSEMBLING THE GRILL
(continued)
Ensure that the burners are positioned correctly on their orifices, and are fully seated onto their
rear hanger brackets (see Fig. 2). The burners should not move side-to-side or front-to-back if
properly seated.
EN
Figure 2
Above each Trellis Burner
is a stainless steel radiant tray containing specially shaped ceramic
briquettes. Position the radiant trays onto the lower ledge of the burner box in the grill, and then
install the cooking grates on the upper ledge (see Fig. 3). The burners and radiant trays work
together to create a very even heat, front-to-back, left-to-right. The radiant trays also serve to
minimize flare-ups, and prevent blockages of the burner ports from falling grease and debris. The
radiant trays and Trellis Burners must be used together and are integral to the performance of the
grill. Do not cook on the grill without them.
Note: Infrared Sear Burners do not require the radiant trays. NEVER place a radiant tray over a
Sear Burner.
Figure 3
12
©2018 Hestan Commercial Corporation

Publicité

Table des Matières
loading

Table des Matières