Before Using Your Wine Cellar; Installation Of Your Wine Cellar - Koolatron WC12-DZ Guide D'utilisation

BEFORE USING YOUR WINE CELLAR

• Remove the exterior and interior packing.
• Before connecting the Wine Cellar to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR WINE CELLAR

• This appliance is designed for free standing installation. Allow 2" (50 mm" of space between the
unit's side and 4" (100 mm) between back and the wall.
• Place your Wine Cellar on a floor that is strong enough to support it when it is fully loaded. To
level your Wine Cellar, adjust the front leveling leg at the bottom of the Wine Cellar.
• Locate the Wine Cellar away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
• Avoid locating the unit in moist areas.
• Plug the Wine Cellar into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning about power and/or grounding should be directed toward a certified electrician or an
authorized products service center.
50 mm
2 in
INSTALLATION
100 mm
4 in
50 mm
2 in
4
OPERATING INSTRUCTIONS
1. Insert the power plug into the power socket. Make sure the power socket is 110-120V AC/60Hz.
upper zone
temp. display
zone
switch
2. Set the desired cooling temperature by pressing the buttons
temperature. Each depression of the buttons will scroll through the available temperature
settings. Numbers will flash while setting. Solid numbers indicate the current internal
temperature in Fahrenheit degrees.
3. Allow the empty Wine Cellar to operate for approx. 3 hours. This will allow it to reach
the desired temperature.
4. Fill the wine cooler with your choice of wine bottles. Allow 24 hours of operation before
the bottles reach the desired temperature.
5. The centre touch control button operates both the interior light and switches the temp.
display from Celcius to Fahrenheit. Touch once to turn the interior light on or off. To
switch between Celcius and Fahrenheit, hold button for 4 seconds.
The Wine Cellar should be placed where the ambient temperature is between 59°F to 77°F (15°C
to 25°C). If the ambient temperature is above or below this range, the performance of the unit
may be affected. For example, placing your unit in extreme cold or hot conditions may cause
interior temperatures to fluctuate.
RECOMMENDED TEMPERATURES FOR CHILLING WINE
Red Wines: 58-65°F (15-18°C)
White Wines 46-57°F (8-15°C)
The above temperatures may fluctuate depending on whether the interior light is ON or OFF or
the bottles are located on the upper/middle/lower section
bottom zone
temp. control
temp. display
interior light
and °C or °F switch
or to set your desired
5